Putting On The Harness; Balancing The Brushcutter; Start Engine - Dolmar LT-30 Manual De Empleo Y De Seguridad

Putting on the harness

(only MS-30 U, MS-30 C)
C

Balancing the brushcutter

(only MS-30 U, MS-30 C)
D
5
E

Start engine

F
3
4
- Put on the harness as shown in figure C.
- Adjust it so that the clip is about a hand-width above your
hipbone.
- The ground clearance will depend on the kind of cutting
tool selected.
- When using the trimmer head on a level terrain, the trimmer
head should touch the ground lightly without the user
having to hold the unit.
- In difficult terrain or when using the steel bush cutter or 8-
tooth eddy blades the brushcutter should balance about
20 cm above the ground without the user having to hold
the unit.
- Fuel the brushcutter and clip it into the harness (E/3).
- To balance the brushcutter, loosen the bolt (E/5). Push the
eyelet (E/4) forward to move the centre of gravity back to-
wards the engine, or back to move the centre of gravity
forward towards the tool.
- When you are satisfied with the balance tighten the bolt
(E/5).
Observe accident-prevention regulations!
Do not start the brushcutter until fully assembled and in-
spected!
Starting the engine
- Move at least 10 feet (3 meters) away from where you filled
the fuel tank.
- Make sure you have a good footing, and lay the brushcutter
on the ground in such a way that the cutting tool is not
touching the ground or anything else.
15