Home Decorators Collection 51528 Guía De Uso Y Cuidado página 11

Assembly - Hanging the Fan (continued)
6
Wiring the fan to the receiver
WARNING: Remove the rubber motor stops on the bottom of the
fan before installing the blades or testing the motor.
IMPORTANT: Use the wire connecting nuts (BB) supplied with
your fan. Secure the connectors with electrical tape and ensure
there are no loose strands or connections.
IMPORTANT: If after this step, you decide to check that the
electrical connections have been successful, it is critical to
attach the light kit using the quick connector prior to testing.
The fan will not operate unless the light kit is connected to the
fan.
NOTE: The fan comes with 54 in. lead wires for use with an
extended ball/downrod assembly. If using the 6 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your
desired length (no shorter than 13.5 in.).
□
The fan comes with 54 in. lead wires for use with an extended
ball/downrod assembly. If using the 6 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your
desired length (no shorter than 13.5 in.) This will make extra
room in the canopy (C), if you do not wish to cut the wires,
you will need to neatly wrap them.
□
Connect the fan motor white wire to the receiver white wire
using a wire connecting nut (BB).
□
Connect the fan motor black wire to the receiver black wire
using a wire connecting nut (BB).
□
Connect the fan motor blue wire to the receiver blue wire
using a wire connecting nut (BB).
□
Connect the fan motor orange wire to the receiver orange
wire using a wire connecting nut (BB).
□
Secure each wire connecting nut using electrical tape.
□
Turn the wire connecting nut (BB) upward and push the wiring
into the outlet box (MM).
Receiver (K)
Receiver
Antenna
ON DIP
1 2 3 4
Blue
Orange
Orange
Blue Black White
BB (x4)
11
Please contact 1-800-986-3460 for further assistance.
Outlet box
in the ceiling
(MM)
Green or bare
Black White
HOMEDEPOT.COM/HOMEDECORATORS