Installing The Glass Shades And Bulbs - Home Decorators Collection 51528 Guía De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Attaching the Lights
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
NOTE: Notice the location of the fan's slide switch. This is
the switch used to change the fan's directional rotation.
For more information on the operation of this switch, see
Operating Your Fan and Remote Control on page 14.
Remove the three screws (LL) on the light box of the light kit
fitter assembly (H).
Connect the wires from the light kit fitter assembly (H) to the
wires from the light box of the fan-motor assembly (E) by
connecting the molded adaptor plugs together (blue to black,
white to white). Carefully tuck all wires and splices into the
light box .
Align the three holes in the light box of the light kit fitter
assembly (H) with the three holes in the light box cover of the
fan-motor assembly (E). Position the light kit fitter assembly
(H) and re-install the three screws (LL) that were removed in
first step to secure the light kit fitter assembly (H).
2
Installing the glass shades
and bulbs
CAUTION: Make sure the power is off before attaching or
removing the glass shades.
CAUTION: Do not over tighten the hex nut, overtightening the
hex nut may cause the glass to break.
WARNING: Allow the glass shades to cool completely before
removing.
WARNING: Over lamping the fan will result in the fan lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off, replace the bulbs with the
correct wattage bulbs, and turn on.
Remove the rubber washer (O), hex nut (P), and bottom cover
(Q) from the threaded nipple of the light kit fitter assembly
(H).
With power off, install the two incandescent bulbs (J) (Max.
60-Watt, included) by screwing into the light bulb sockets.
Position the glass bowl (I) over the threaded nipple.
Re-install the rubber washer (O), hex nut (P) and bottom
cover (Q) to the threaded nipple to secure the glass bowl
properly.
13
Please contact 1-800-986-3460 for further assistance.
E
LL
H
E
J
I
O
P
Q
HOMEDEPOT.COM/HOMEDECORATORS

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1001 029 136

Tabla de contenido