Hanging The Fan - Home Decorators Collection 51528 Guía De Uso Y Cuidado

Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock, or other
personal injury, mount the fan to an outlet box or supporting
system marked "Acceptable for fan support of 35 lbs.
(15.9kg) or less" and use the mounting screws provided
with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into place
on an outlet box with the outlet box screws (II).
□
Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□
Install the ceiling slide-on mounting bracket (A) on the outlet box
by sliding the slide-on mounting bracket (A) over the two screws
(II) provided with the outlet box. If necessary, use leveling washers
(not included) between the slide-on mounting bracket (A) and
the outlet box. Note that the flat side of the slide-on mounting
bracket (A) is toward the outlet box.
□
Securely tighten the two mounting screws (II).
3
Setting the code on the remote control and receiver
NOTE: The frequencies on your receiver and hand unit have
been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and hand unit are
set to the same frequency. The dip switches on the hand unit
are located inside the battery compartment.
NOTE: The switch marked ON/DIM controls the dimming
function of the lights: If using CFL bulbs, use a ballpoint pen
or small screwdriver to set the switch to ON to disable the
dimming function. If using standard bulbs, set the switch to
DIM to enable the dimming function.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
hand unit. Dispose of used battery properly and keep the
battery out of the reach of children.
□
Remove the remote control (L) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the dip switches to your choice of either up or down.
The factory setting is up.
□
Slide the dip switches (JJ) on the receiver (K) to the same
position as set on the remote control (L).
□
Replace the battery cover on the remote control (L).
2

Hanging the fan

WARNING: The hook as shown is only to balance the fan
while attaching wiring. Failure to hang as shown may
result in hook breaking, causing the fan to fall. The hook
must pass from inside to the outside of the canopy (C).
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket socket. Ensure that the tab on the
slide-on mounting bracket (A) socket is properly seated in the
groove in the hanger ball.
ON DIP
ON DIM
1 2 3
12V 23A
K
9
Please contact 1-800-986-3460 for further assistance.
A
B
C
E
ON DIP
ON DIM
1 2 3 4
JJ
L
4
ON DIP
1 2 3 4
HOMEDEPOT.COM/HOMEDECORATORS