Operation - Home Decorators Collection 51528 Guía De Uso Y Cuidado

Operating Your Fan and Remote Control
Remote Control - Your fan is equipped with a remote control to operate
the speed and lights of your new ceiling fan.
Speed setting for warm or cool weather depends on factors such as
the room size, ceiling height, number of fans and so on.
The fan is shipped from the factory with the reversing switch (YY)
positioned to circulate air downward. If airflow is desired in the
opposite direction, turn your fan off and wait for the blades to stop
turning, then slide the reversing switch (located in top glass housing)
to the opposite position, and turn the fan on again. The fan blades will
turn in the opposite direction and reverse airflow.
NOTE: Wait for the fan to stop before reversing the direction of the
blade rotation.
Warm weather - (Forward) A downward airflow creates a cooling effect.
This allows you to set your air conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
Transmitter operation
NOTE: This remote is equipped with a 16-code combination. To prevent
possible interference from or to other remote units such as garage
door openers, car alarm or security system, change the combination
code but be sure that the code on both the hand held transmitter and
receiver in the fan are the same.
NOTE: Pressing on the middle of the light button, will turn on the
uplight only.
Install a 12-V battery (included).
□
Remove the protective coating from the battery.
□
Remove the battery cover from the remote control.
□
Install the 12-Volt battery (included) into the battery compartment of
the remote control (L).
□
Replace the battery cover on the remote control.
□
Press the desired button on the remote control (L) to operate the fan:
□
"3" button: Press to turn the fan on and set the fan speed to high.
□
"2" button: Press to turn the fan on and set the fan speed to me-
dium.
□
"1" button: Press to turn the fan on and set the fan speed to low.
□
Power button (NN): Press to turn the fan off.
□
Uplight button (OO): Press and release immediately to turn the
uplight on or off. Press and hold to dim or brighten the bulbs to the
desired level and then release(the dimmer function is for Tungsten
bulbs only).
A. Warm weather
B. Cool weather
□
Downlight button (PP): Press and release immediately
to turn the downlight on or off. Press and hold to dim or
brighten the bulbs to the desired level and then release
(the dimmer function is for Tungsten bulbs only).
14
Power Indicator will light
when buttons are pushed
ON/High
ON/Medium
ON/Low
NN: Power OFF
OO: Up Light ON/OFF
& Dimmer Function
PP: Down Light ON/OFF
& Dimmer Function
L
YY