Resetting Handsets; Registering Handsets; Adapter And Battery Information - Uniden D1680 Serie Guia Del Usuario

Installing a Line Filter or DSL
Filter
A telephone line filter or DSL filter
prevents services that use the phone
line from causing interference on your
phone. To get a line filter, contact your
service provider or look in an electron-
ics store.
Plug the filter into the telephone wall
jack and plug the base into the filter.
Make a test call to make sure the noise
is gone.
Liquid Damage
CAUTION: If the base is covered in
liquid, disconnect the adapter &
phone cord from the wall before
touching it.
If the liquid is only on the exterior
housing of the base or handset, wipe it
off and use as normal. If you can hear
liquid inside the housing:
1. Remove all compartment covers,
and disconnect all cables and cords.
2. If liquid is leaking from any vent
or hole, turn the phone so that vent
faces down. If not, place the largest
vent face down.
3. Let dry for at least 3 days. Check
for liquid inside the phone before
replacing compartment covers &
reconnecting cords.

Resetting Handsets

If you have trouble with a handset or
if you want to replace one, clear the
registration information from the base
and the handset:
and # at the same
1. Press & hold
End
time until you see the
menu.
2. If you still have the base the handset
is registered to, select
then select the handset you want
to reset. If you don't have that base
Base
anymore, select
1
3. To confirm, select Yes. The handset
displays

Registering Handsets

If you see a "not registered" message on
a handset, you must register it to a base
before using it.
1. Place the handset in the base;
the display should say
Registering.
2. Wait until the display says
Registration Complete
seconds), then pick up the handset
and press
3. If you don't hear a dial tone or the
display says
charge the battery completely, then
try again.
Adapter and Battery
Information
AC adapter
Part number
Input voltage
Output voltage
Use only the supplied AC adapters.

Use the proper adapter for the base &

any chargers.
Do not place the unit in direct sunlight

or subject it to high temperatures.
Battery pack (with normal use)
Part number
Capacity
Talk time
Standby time
Battery life
System Reset
Replace the battery when the talk or

standby time becomes noticeably re-
duced. For replacements, call the Parts
Department (see the front cover).
Deregister HS,
When the battery gets low, the handset

beeps and shows a low battery alert; put
the handset in the cradle for recharg-
Unavailable.
ing.
Handset not registered.
Handset
(about 30
Talk/flash .
Registration Failed,
PS-0035
120V AC, 60 Hz
8V AC @ 300mA
BT-1021
300mAh, 2.4V DC
about 7 hours
about 7 days
about 1 year