Cleaning And Maintenance - vitapur VWD2266W Manual D Uso Y Cuidado

Ocultar thumbs Ver también para VWD2266W:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dispensing Cold Water
Place a glass under the spigot. For cold water, press the
button. (For hot water, see
Dispensing Hot Water).
Adjusting the Temperature (Cold water only)
By turning the thermostat at the back of the unit, the temperature
TEMP
can be adjusted. Turn (rotate) the dial between the "Min" and "Max"
settings until the desired temperature is reached.
Rotate control "clockwise" for colder temperature. Rotate control
"counter-clockwise" for warmer temperature. If the water dispenser is
not dispensing water, there could be a possible ice build up due to the
Min.
Max.
thermostat being set too cold. If this happens, unplug the dispenser
overnight and then reset. Set thermostat to Min, slowly increasing
based on your use and need for cold water.
Dispensing Hot Water
Place glass/cup under spigot. Press the red child safety lock, (located at the front of the
button) while at the same time pressing the hot water button down until the desired amount of
water is dispensed. Release button and the child safety lock re-engages (locks) automatically.
Child Resistant Safety Switch
To prevent hot water from being dispensed accidentally
and possibly harming a child, the hot water dispensing
tap can only be operated when the child resistant safety
feature is activated. To activate this feature, push the red
button on the front of the hot water button and hold.
DANGER:
The hot water is heated to approximately 194˚
F / 90˚C. Temperatures above 125˚ F / 52˚ C can cause
Child resistant
safety switch
severe burns from scalding. DO NOT ALLOW CHILDREN
TO USE THE HOT WATER DISPENSING BUTTON
WITHOUT PROPER AND DIRECT SUPERVISION.

CLEANING AND MAINTENANCE

Like most appliances, your water dispenser requires periodic maintenance for maximum
efficiency and performance and must be cleaned on a regular basis (i.e. every 4 months). To
maintain a hygienic environment within your water dispenser and prevent potential formation
(growth) of bacteria, we strongly recommend regular cleaning. A cleaning kit is available
through our Customer Service Department at 1-866-253-0447 or can be ordered on line at
www.greenwayhp.com.
Cleaning Your Water Dispenser
IMPORTANT:
Make sure you unplug the dispenser and switch off the heating power switch at
the rear of the unit before performing any of the following cleaning procedures.

Publicidad

Tabla de contenido
loading

Tabla de contenido