SUOMY apex Manual Del Usuario página 24

ENG
USER'S INSTRUCTIONS
Do not use paper cloths to clean and dry the visor.
Do not expose the visor to heat to dry.
Do not use particular detergents (prepared solutions, creams, etc.) even if they are classified "specific for visors unless directly marketed by
Suomy.
Caution: do not clean the visor inside, because the ANTIFOG MIST RETARDANT (FOGCITY® film) could be damaged and thus affect
the duration and efficiency of the visor itself. Suomy therefore, cannot be held responsible if this should occur.
During cleaning operations, carefully handle the visor to avoid damaging the anti-scratch and anti-fog coating. Never use solvents, alcohol, fuels,
thinning substances or abrasive powders; these materials are aggressive and could affect the structural resistance of the polycarbonate or scratch
the surface of the visor thus damaging the mechanical and optical properties..
Some colourings are made with Fluo UV paints that could be subject to the natural migration phenomenon with a drop in intensity.
The phenomenon could be enhanced when the helmet is exposed for long periods to a particularly intense light. However, this does not
affect the performances and the quality of APEX.
Suomy therefore, cannot be held responsible if this should occur.
USER'S INSTRUCTIONS
RETENTION SYSTEM «D-RING» see figure 2
Insert the free side of the strap in the rings.
Pull the end until the strap presses firmly against the jaw.
After this operation, it should not be possible to remove the helmet. Verify that by grabbing it from the back and rotating it to the front it cannot
be removed and it is fixed to the head.
If the helmet tends to come off or rotates freely, tighten the strap again until the right pressure is obtained and repeat test.
If after repeating the test you are not able to efficiently tighten the retention system, do not use the helmet.
Only after checking the correct tension of the strap, fix the free end locking it with the automatic stud to the release tab (see figure 2).
22