SUOMY apex Manual Del Usuario página 25

The automatic stud is necessary only to fix the free end of the strap to prevent it from flapping while riding.
Fixing the release button does not assure that the helmet is correctly in position and properly fastened: the correct locking of
the strap must be verified exclusively following the above paragraphs.
To release the retention system, release the automatic stud button and pull the release tab to loosen the closure. Slide out the free end of the
strap from the «D Rings».
Use the release tab only to remove the helmet! Never release this tab while riding.
If the retention system does not work properly, do not use the helmet and contact Suomy authorized personnel only.
CHIN GUARD AIR INTAKE AND FRONT AIR INTAKE
The air flow coming in from the chin guard can be adjusted by using the lever (A) positioned in the central part of the air intake:
- Position (X): lever (A) up - air intake completely closed.
- Position (Y): lever (A) middle position - air intake partially open.
- Position (Z): lever (A) down- air intake completely open.
The air flow coming in from the top/front part of the helmet, can be adjusted by using lever (B) on the upper part of the air intake.
- Position (X): lever (B) up - air intake completely closed.
- Position (Z): lever (B) down - air intake completely open.
figure 2
X B
A
USER'S INSTRUCTIONS
Y Z
A
ENG
see figure 3
B
A
figure 3
23