Control Stop Valve Operation - Kohler K-10675 Guía De Mantenimiento

Wall Tube

Control Stop Valve Operation

NOTICE: Refer to this section throughout the Maintenance Guide
when instructed to close and open the control stop valve.
NOTE: A flat-blade screwdriver must be used to remove the stop
cap and adjust the valve position.
Using a flat-blade screwdriver, pry the vandal-resistant stop cap
from the control stop.
To close the stop valve: Turn the valve screw clockwise until the
end of travel is reached.
To open the stop valve: Turn the valve screw counterclockwise
until the end of travel is reached.
When done, place the cap on the control stop, then gently tap the
control stop into place with the screwdriver handle.
1108712-5-C
Wall Flange
Control Stop
Stop Cap
6 Kohler Co.