Install The Dc Sensor - Kohler K-10675 Guía De Mantenimiento

Screw
DC Sensor

Install The DC Sensor

NOTE: The DC sensor must be installed as shown in the
illustration.
Hold the cap horizontally with the sensing holes down and align
the DC sensor assembly with the cap.
Slide the DC sensor assembly into the cap small-side first until
the sensor eyes align with the holes in the cap.
Insert the clip between the back of the DC sensor and the case, as
shown. Push it in until the bottom of the tab stops on the sensor.
Connect the DC sensor connector to the solenoid connector on the
valve. Ensure the arrows on both connectors are aligned.
NOTICE: Ensure that the wires are not caught between the cap and
the valve body.
Place the cap on the valve body and install the hex screw.
Open the control stop valve.
Replace the vandal-resistant cap on the control stop.
Verify the valve functions.
Kohler Co.
Cap Assy
Clip
9 1108712-5-C