Install The Solenoid - Kohler K-10675 Guía De Mantenimiento

Body

Install The Solenoid

Ensure that both O-rings are installed on the bottom of the new
solenoid.
Align the solenoid with the connecting wire facing the outside of
the unit, as shown.
Align the solenoid to the holes in the valve body.
Retighten the two screws into the solenoid.
Align the two arrows on the connectors so that they point to one
another, then connect them.
NOTICE: Ensure that the solenoid wires are not caught between the
cap and the valve body.
Place the cap on the valve body, then reinstall the hex screw.
Open the control stop valve.
Verify the valve functions.
Kohler Co.
Screw
Solenoid Assy.
11 1108712-5-C