Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 8
OUTSIDE SUPPORT MOUNTING – Assemble the support brackets (Item #1) to the bottom rails of the cab i net with four
(4) 10-24 1" long screws (Item #2) and four (4) 10-24 fl at nuts (Item #3). Adjust the support brackets to bring the bottom pads
in contact with the wall surface. (A 1" x 4" or 2" x 4" SPACER SHOULD BE USED BETWEEN THE WALL AND THE
SUPPORT BRACKETS WHEN IN STALLED ON ALU MI NUM OR VINYL SIDING). Drill
the brack ets to the wall with two (2) #12A x 2" long screws (Item #4). Adjust the support brackets to provide an ap prox i mate
3/8" down slope toward the out side for drainage. (See Figure D, Page 4). Tighten all screws.
NOTE: The supply air, intake air, condenser air inlets and outlets must be unobstructed to avoid recirculation of rejected heated air.
The illustrations below show a standard frame con struc tion installation as well as some suggested ways of adapt ing the
support bracket to thick walls and large stone ledges.
FIGURE 1
SUPPLY AIR
RETURN AIR
FIGURE 3
STONE LEDGE
10 - 24 SCREW
10 - 24 FLAT NUT
⅜" SLOPE
DOWN
CONDENSER
AIR OUTLET
CONDENSER
AIR INLETS
#12A x 2" SHEET
METAL SCREW
1" x 4" OR 2" x 4" SPACER
BE TWEEN WALL AND
BRACKET SHOULD BE USED
ON ALUMINUM, ASBESTOS
OR VINYL SIDING.
⅜" SLOPE
DOWN
#12 x 2" SHEET
METAL SCREW
2" x 4" SPACER
920-036-05 (10-04)
FIGURE 2
CUT
HERE
DISCARD
SHADED AREA
FIGURE 4
STONE LEDGE
5
⁄
" dia. pilot holes and secure
32
⅜" SLOPE DOWN
DIMENSION "A"
STONE LEDGE
OUTSIDE WALL
CUT TO FIT DIMENSION "A"
AND BEND DOWN TO FORM
A VER TI CAL LEG.
⅜" SLOPE
DOWN
STRAIGHTEN TAB TO LAY FLAT
ALONG THE BOTTOM RAIL OF
THE SHELL.
SECURE THE LONGEST SIDE OF
THE BRACKET TO THE SHELL
ADJUST IN OR OUT TO REST ON
LEDGE.
5
Publicidad
Tabla de contenido
