Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FIGURE E
STEP 9
CUT WINGBOARD PANELS – Measure and cut the wingboard panels from the Masonite sup plied (Item #8) to fi t
the spaces between the side window channels and the sides of the cab i net.
(See Figure E.)
NOTE: AFTER CUTTING THE PANELS, MAKE A TRIAL TEST TO SEE IF THEY FIT THE SPACE WITH ABOUT
CLEAR ANCE BEFORE GOING TO STEP 10.
STEP 10
ASSEMBLE THE CLIPS TO THE WINGBOARD PANELS – Assemble the "J" type speed nuts (Item 9) and spring
steel clips (Item 10) to the edges of the cut wingboard panels (See Figure F.)
FIGURE F
SPEED NUT OVER THE SLOT
IN THE WINGBOARD PANEL
INSTALL THE SIDE WINGBOARD PANELS – Be sure the cabinet has been secured to the win dow sill and that
STEP 11
the outside support brackets have been installed as shown in Figures C and D on Page 4. Raise the window sash and
install the right and left side wingboard panels. (See Figure G, Page 7.)
INSTALL THE WINDOW SEALING GASKETS – Measure and cut the vinyl window seal gasket (grey color, Item
STEP 12
# 12) to fi t the width of the window, and install as shown in Figure H on Page 7. Pull the window sash down behind
the gasket. Measure and cut the dark foam window seal gasket (Item #13) and install it between the upper glass panel
and the top part of the lower sash. (See Figure H, Page 7).
NOTE:
FOR REASONS OF SECURITY AND SAFETY, THE CUSTOMER MUST PRO VIDE A MEANS
OF PRE VENT ING THE WINDOW FROM OPENING.
6
"J" TYPE SPEED NUT
(ITEM #9) 2 REQUIRED
CUT WINGBOARD PANEL
CENTER THE HOLE IN THE
920-036-05 (10-04)
MEASURE DISTANCE "B" TO INSIDE OF THE
CHANNEL ON EACH SIDE
CUT HERE AND DISCARD CENTER WASTE
MATERIAL.
WINGBOARD
SUBTRACT ⅛" FROM DIMENSION "B" AND
MEA SURE FROM THE EDGE OF THE WING-
BOARD (ITEM # 8), MARK, AND CUT WITH A
SAW
3"
3"
SPRING STEEL CLIP
(ITEM #10) 2 RE QUIRED
CUT EDGE
SLIDE CLIP OVER CUT EDGE
OF WINGBOARD PANEL
1
⁄
"
8
Publicidad
Tabla de contenido
