Friedrich SS Serie Instrucciones Para La Instalación página 7

FIGURE G
FIGURE H
When possible, caulk the outside of the installation with industrial type caulking to prevent weath er leaks.
STEP 13
STEP 14 INSTALL CHASSIS: After installing the shell, slide the chassis into the shell stopping approximately 3" from full insertion.
Stuff the chassis seal gasket one inch deep between the chassis and the shell (see Figure I, page 8). Begin at either bottom
corner and go up the side, across the top, and down the opposite side. Then push the chassis all the way into the shell for the
remaining distance so that the plastic front meets the front edge of the shell.
If chassis seal gasket is not installed, the operation of the unit will be negatively affected. Also, the operation noise and outside
noise will be amplifi ed.
STEP 15 Reattach the chassis retainer with the same screw as Step 3 (See Figure A, Page 3).
OPTIONAL: The factory assembles the supply cord so that it exits the left side of the unit. At the consumer's discretion, the
STEP 16
supply cord can be made to exit the right side of the unit. To do this, remove the black rubber coated cord clamp from under
the far left screw. (See Fig I, Page 8) Replace this screw back into the far left screw hole. Route the supply cord over the top
of the return air grille clips and reattach the clamp to the adjacent screw hole. (Fig I & J, Page 8) Detach the right side cord
clamp, route the supply cord through it and reattach. The supply cord should be pulled taunt so as not to rest on the return air
grille clips.
SECURE THE SIDE WINGBOARD
PANELS TO THE SIDE ANGLES
WITH FOUR (4) #8 x ½" LONG
SCREWS (ITEM #11), TWO ON
EACH SIDE.
LOWER WINDOW SASH
VINYL WINDOW SEAL
GASKET
TOP WINGBOARD
ANGLE
SECTION B - B
920-036-05 (10-04)
TOP OF CABINET
PLACE WINGBOARD PANEL IN WINDOW JAM
TO COMPRESS THE SPRINGS INSIDE THE
RUNNERS, AND SWING THE PANEL INTO
PLACE INDICATED BY THE DOTTED LINE.
WINDOW JAM
SECTION A - A
VINYL WINDOW SEAL
GASKET (ITEM #12)
FOAM WINDOW SEAL GASKET
(ITEM # 13)
7