Install The Tower Face, Handspray And Showerheads - Kohler K-498 Guia De Instalacion

#6-32 x 1/2"
Sockethead Screw
Screws
Tower Face

9. Install the Tower Face, Handspray and Showerheads

Install the Tower Face
Close the shower valve by rotating the uppermost valve counterclockwise.
Turn on the water supply to the tower and check for leaks. Do not open the shower valve at this
time.
Check the sealant around the water supply lines. Fill any gaps as needed.
Position the tower face onto the tower.
Starting at the bottom and alternating side-to-side, use the sockethead screws to secure the tower
face to the tower.
Install the Handspray
Apply thread sealant to the male adapter.
Thread the handspray hose to the adapter and securely wrench tighten.
Install the Showerheads
NOTE: For ease of showerhead installation, raise the lamp post slightly before installing the showerheads.
Remove the collar from the lamp post.
Slide the collar over the ball joint with the opening facing away from the showerhead.
Ensure that the O-ring is in the ball socket, then snap the ball socket over the showerhead ball joint.
Assemble the collar to the lamp post, making sure the hose O-ring does not get pinched between
the collar and the lamp post.
Kohler Co.
Lamp
Post
Ball Socket
11
Hose
O-Ring
O-Ring
Ball
Joint
Collar
Showerhead
Male Adapter
Apply thread sealant.
Handspray Hose
Tower Face
1010418-2-D