Kit Assembly; Iso Din Radio Provision With Pocket; Iso Ddin Radio Provision; Final Assembly - Metra 99-5832G Instrucciones De Instalación

KIT ASSEMBLY

ISO DIN radio provision with pocket

1. Attach the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips truss
head screws provided in the kit.
(Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the completed
assembly and then secure it using the
screws supplied with the radio.
(Figure B)
Continue to Final Assembly

ISO DDIN radio provision

1. Attach the radio brackets to the radio
using screws supplied with the radio.
(Figure C)
Continue to Final Assembly
(Figure A)
(Figure B)
(Figure C)

FINAL ASSEMBLY

1. Cut the shaded portion from the sub-
dash of the vehicle to allow the radio to
fit. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS.
Remove shaded area
(Figure A)
3. Reconnect the negative battery terminal
and test the radio for proper operation.
4. Slide and secure the radio assembly into
the dash and snap the trim panel onto
the radio.
5. Reassemble the dash in reverse order of
disassembly.
REV. 06/28/2021 INST99-5832G
3