Nortek NDVT3000 Manual De Instrucciones página 25

press STOP to exit during scanning, Chart (30).
Chart (30)
By selecting auto-scan, at the option of "Select Area", select country/are
scanned by <LEFT>, <RIGHT> direct key, then press <ENTER> key at "Start Scan"column,
and the system enters Chart (31) interface and start scanning. The first channel will be
played after the completion of scanning.(2)Manual Scan, Chart (32)
B y selecting manual scan, the options of scan settings are: A) country, B) scan mode, C)
boot point, D) start frequency, E)close point, F)end frequency, G)frequency band. The scan
modes are Single Channel and Channel Range. Single Channel is for channel scan of
single frequency, and the user can only set up on country and boot point, while Channel
Range is for channel scan of certain frequency band, it enables the user to set up the
scanning on country, boot point and close point. By <UP>/<DOWN> key to select options,
<LEFT>, <RIGHT> key to select relevant optional parameters. After setup, press shift
cursor to select "Start Scan" and press <ENTER> to start scanning. The first channel will be
played after the scanning is completed. Press <RETURN TO>/<SETUP> to escape and
return to the main menu interface.
(3)Default Setup, Chart (33)
S electing default setup option and the warning dialog of whether reset all present settings to
Chart (32)
Chart (33)
GB-24
Chart (31)
a that needed to by