Activating And Resetting The Cpr Release; Removing Or Replacing The Headboard - Stryker SV2 Manual Del Operador

Activating and resetting the CPR release

WARNING
Always make sure that all persons and equipment are away from the area below and around the backrest before you
activate the CPR release. The CPR release is for emergency use only.
If the backrest is raised and you need quick access to the patient, you can position the product to 0° by activating the
CPR release.
You can find the instant CPR release lever at the head end section on both the left and right sides of the backrest.
To activate the CPR release:
1. Grasp either lever (A) and pull outward
2. Guide the backrest down to the flat position.
To reset the backrest motor after activating the CPR release, press the backrest down button on the control panels or
the CPR button on the nurse control panel.

Removing or replacing the headboard

WARNING
Always properly orient the headboard when replacing the headboard to avoid entrapment.
You can remove the headboard for patient accessibility and cleaning.
To remove the headboard:
1. Hang the patient control pendant onto the head end siderail.
2. Grasp the handles and lift the headboard straight up and off the product
To replace the headboard:
1. Align the curved headboard corners with the foot end of the bed
2. Align the headboard pegs (A) with the plastic sleeves (B) at the head end of the product
www.stryker.com
Operation
(Figure 1-13 on page 1-23).
Figure 1-13: CPR release
(Figure 1-14 on page
KK-7500 REV 02
(Figure 1-15 on page 1-24).
1-24).
(Figure 1-15 on page
English
EN
1-24).
1-23