Horizon Global 24980 Instrucciones De Instalación página 4

1. Lower Muffler - Using exhaust removal pliers, remove the (2) rearmost
rubber exhaust hangers. Spraying a lubricant will help the removal
process. Note: Be sure the exhaust is supported before removing from
rubber hangers to prevent damage.
3. Lower Carbon Canister - Lower the carbon canister from driver side frame
by removing the rearmost (1) M8 bolt using a 10mm socket and allowing the
cannister to hang. NOTE: If present remove frame rail plug, to access rear
mounting point on the driver side.
©2019 Horizon Global™ Corp. - Printed in Mexico
2. Remove Heat Shield - Remove (4) metal fasteners that hold the heat shield in
place with 15/16" socket. Take the heat shield off and trim the area marked in
Figure 3.
NOTE: All dimensions are approximate, confirm fit prior to trimming.
Figure 2
4. Enlarge attachment holes - Using die grinder, enlarge the forward
most attachment hole of driver and passenger side frame rails to insert
carriage block and bolt. see Figure 3.
Sheet 4 of 18 24980NP
Trim
8.5"
5"
01-10-19 Rev. A