Horizon Global 24980 Instrucciones De Instalación página 5

5. . Install carriage bolts and spacers – Install spacer block and carriage bolt
into rearward attachment holes in the frame through the enlarged holes on
both sides using fish wire per Fig. 4, leave the fishwires attached. Install spacer
block and carriage bolt into forward attachment holes in the frame through
the enlarged holes on both sides using fish wire per Fig. 5, leave the fishwires
attached.
8. Center Hitch - Center the hitch on the vehicle as close as possible.
©2019 Horizon Global™ Corp. - Printed in Mexico
6. Reinstall heat shield – Reinstall the trimmed heat shield.
7. Install hitch – Raise the hitch into position, line up the hitch slots with
the attachment holes and install the nut and conical washer (teeth side
toward hitch) on both sides and hand tighten them as shown Fig 1. Note:
on passenger side sandwich the heat shield between the frame rail and
the hitch.
9. Tighten Fasteners - Tighten all 7/16"-14 fasteners with torque wrench
to 50 Lb.-Ft. (68N*M)
Proper torque is needed to keep the hitch secure to the vehicle when
towing.
Sheet 5 of 18 24980NP 01-10-19 Rev. A