Message
Open window and check
printhead cover is properly
closed
Out of memory.
Data was lost
Out of paper
Paper advance calibration is
recommended.
Press ENTER to calibrate
Paper loaded with too much
skew
Press ENTER to retry
Press CANCEL to abort
Printhead warning
Poor print quality
Roll edge not found
Please check roll edges are
non-clear
Press ENTER to retry
Press CANCEL to abort
Sheet not loaded
Load sheet with printed pattern
Warning! Machine calibrations
need to be performed. Refer to
guide for instructions.
Warning: printheads not
aligned
3
Introductory Information
Explanation and action
Open the window and check the printhead cover.
Note:
This message may also appear following a paper jam, as the printer
cannot detect the exact reason for the problem. In this case you may have to
power off the printer and even remove the power cable from the machine, in
order to recover from the problem.
The file is too large to be processed by the printer.
Simplify the print and try re-sending the job. Try setting the
the
Set-up
menu) to
Fast
may have to add more memory to the formatter card that is installed in the
back of the printer.
The printer ran out of paper while printing the calibration pattern.
Load a sheet or roll that is at least 65 cm (25 inches) long and 50 cm (20
inches) wide.
You are recommended to perform the Advance calibration routine, to ensure
the optimum print quality.
Press the
Enter
key to create the calibration pattern.
During the loading of paper, the printer has detected that the paper is skewed
too much, that is, it has not been loaded straight enough. ('Skew' is the angle
between the actual paper edge and the correct line.)
Either:
Press the
Enter
key to restart the loading procedure;
Or:
Press the
Cancel
key to cancel paper loading.
A problem has occurred with one or more printheads. The printheads are
still functional. The problem was detected either during printhead alignment
or during troubleshooting. If you have completed the routine, the system was
unable to clean the printheads fully.
You should use the
Troubleshooting
problems that may be apparent; alternatively, you should replace the
printheads.
During the loading of a roll, the printer cannot detect the side edge of the
paper. A possible cause is that the paper is transparent (clear); only opaque
paper types are supported.
Either:
Press the
Enter
key to restart the loading procedure;
Or:
Press the
Cancel
key to cancel paper loading.
The printer is trying to perform a scan of the calibration pattern, but no sheet
was found.
Load the sheet that was printed by the
routine.
The color calibrations for the paper that is loaded have been lost.
Repeat color and advance calibrations.
The printer has detected that the printheads have not been aligned since the
last replacement.
You should align the printheads by selecting
menu.
or
Normal
instead of Best. If the problem persists, you
routine to correct any image quality
Create pattern
Align printheads
Print Quality
(in
part of the calibration
from the
Ink