I Starti Ng A Cleaning Cycle - Polaris W 630 Manual De Instalación Y De Uso

2.4 I Starti ng a cleaning cycle

In order to avoid any risk of injury or material damage, please follow the instructi ons below:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during a shock chlorinati on. Wait unti l the chlorine level has reached
the recommended value before immersing the cleaner.
• Do not leave the appliance unatt ended for an extended period.
• Do not use the appliance if the roller shutt er is closed.
• When the control box is powered up, the following symbols light up to indicate:
- The acti on in progress
- The cleaning mode selected
- that maintenance is required
• The control box switches to standby aft er 5 minutes and the screen and the LEDs are switched off . Press any key to
exit standby mode. Standby mode does not stop the appliance if it is in a cleaning cycle.
2.4.1 Choice of cleaning mode
• By default, Smart mode is the pre-set cleaning mode (cleaning the fl oor, walls and waterline over an opti mised period
of ti me depending on the pool's dimensions).
• During the fi rst cycle launched in Smart mode, the cleaner explores the pool while cleaning for a cycle lasti ng 2h30.
During this fi rst cycle, the control box displays "AUTO/2h30" (depending on the model). At the end of this cycle, the
opti mum cleaning ti me is calculated.
• This opti mum cleaning ti me is then saved and becomes the default cleaning ti me for future cycles launched in Smart
mode. The control box then displays the opti mum ti me calculated.
• To reset Smart mode, press and hold the
cleaner recalculates the opti mum cleaning ti me.
• The cleaning cycle can be modifi ed before the appliance starts or while it is operati ng. The new mode will be started
immediately and the remaining ti me from the previous cycle will be cancelled.
• Press :
- Floor only mode:
- Smart mode (Opti mised cleaning of the fl oor, walls and waterline):
- Ultra mode (Intensive cleaning of the fl oor, walls and waterline):
- Waterline only mode:
• Press to start the cleaning cycle.
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in fl oor only mode (aft er removing the large
debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the fi lter less clogged.
2.4.2 Adjusti ng the cleaning ti me (depending on model)
• You may reduce or increase the ti me for the cleaning cycle selected or in progress:
- : Reduce by 15 minutes.
- : Increase by 15 minutes.
11
butt on for 5 seconds. Launch a new cycle in Smart mode so that the
(depending on the model)
(depending on the model)