I Operati Ng Principle; I Pool Preparati On - Polaris W 630 Manual De Instalación Y De Uso

1.3 I Operati ng principle

The cleaner is separate from the fi ltrati on system and can functi on independently. It just simply needs to be connected
to the mains power supply.
It fi nds the best route to move around and clean the areas of the pool for which it has been designed (depending on the
model: fl oor, walls, waterline). Debris is sucked in and stored in the cleaner's fi lter.
The cleaner can be used:
- via the control box supplied with the cleaner,
- or via a smartphone or a tablet compati ble with the iAquaLink™ applicati on (see "❸ Using the iAquaLink™ app").

1.4 I Pool preparati on

• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The appliance must operate in pool water with the following properti es:
Water temperature
Free chlorine
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to opti mise the
appliance's performances.
• Remove any thermometers, toys and other objects that might damage the appliance.
7
3.5 metres Minimum
pH
"iAquaLink™" Wi-Fi
Between 15°C and 35°C
Between 6.8 and 7.6
< 3 mg/ l
: Control box
: Trolley
: Cleaner
: Floati ng cable
: Plug
: Power cord
: Remote control