Stalgast KGPG-4 Serie Manual De Instrucciones página 51

Thermal
Alignmentof air
power of the
shutter (mm)
burner (kW)
9,0
7,0
5,0
3,5
9,0
7,0
5,0
3,5
9,0
7,0
5,0
3,5
9,0 H = 22
7,0 H = 20
5,0 H = 20
3,5 H = 20
9,0
7,0
5,0
3,5
9,0 H = 18
7,0
5,0
3,5
8.3. Installation
The stove may be connected to the gas installation or to the gas cylinder only by a person
authorized to perform installation services. Conversion of the stove to another type of gas must
be carried out by an authorized installer.
•
After unpacking make sure that the unit does not show any visible damage. If the unit has been
damaged during transport, do not connect it!
•
The protective foil must be removed from the unit before the start-up. Wash the outer surfaces with
a cloth wet in warm water and degreasing agent, and then dry them out. Do not use any agents that
could scratch the surface.
•
Facilities in which gas appliances are to be installed must comply with the installation regulations
of the country, in which they are to be installed.
•
The stove should be positioned in a well-ventilated room. It is necessary to ensure a unblocked inflow
of air to the stove (it is necessary during the gas combustion process) as well as safe exhaust discharge
(do not place the stove in recessed parts, do not block it with high appliances/cabinets aside, etc.).
When the kitchen is placed against a wall, the minimum distance should be as follows:
•
from a non-flammable wall according to installation possibilities,
•
from a protected flammable wall, i.e. a wall made of flammable materials, but rendered or pro-
tected in an evenly distributed manner - not less than 30 cm
•
from an unprotected flammable wall, i.e. a wall made of wood or other flammable materials - not
less than 60 cm
•
Stoves adapted for combustion of LPG must not be installed below the grade level (e.g. basements).
•
The temperature of rooms of cylinder installation shall not exceed 35oC. The kitchen should be leveled
with adjustable feet as shown in Fig. 18 (adjustment range - from -20 to 40 mm).
Setting the burner shutter
Type of
gas
H = 16 G27
H = 14 G27
H = 14 G27
H = 14 G27
H = 14 G20
H = 12 G20
H = 12 G20
H = 12 G20
H = 16 G20
H = 14 G20
H = 14 G20
H = 14 G20
G30/31
G30/31
G30/31
G30/31
H = 21 G30/31
H = 19 G30/31
H = 19 G30/31
H = 19 G30/31
G30/31
H = 16 G30/31
H = 16 G30/31
H = 16 G30/31
Gas
pressure
(mbar)
20
20
20
20
25
25
25
25
20
20
20
20
30
30
30
30
37
37
37
37
50
50
50
50
- 51 -