Display; Operation; Ignition; Use - Elframo NE-M 120 Manual Del Usuario

4.1.

Display

The deep fryer's display has a selector switch (0-1), a knob for adjusting the temperature and two LED indicators.
Selector 0 – 1
Temperature control

5. Operation

5.1. Ignition

Turn the selector clockwise to position 1
Turn the temperature control knob to the
goes off when this temperature is reached.
If the power indicator (LED 1) goes off, it means that the safety thermostat has tripped. To return to normal working mode,
reset the safety thermostat (at the bottom of the electrical box) by pressing this with sufficient force. Request expert
technical assistance if the problem persists.
If using fat instead of oil, we recommend heating this gradually.

5.2. Use

At this point the machine is ready to fry food according to the maximum product capacity mentioned at point 3.1

5.3. Shutdown

After using the fryer, return the temperature control knob to the position marked "°C" and
clockwise to position 0.

5.4. Emptying the tank

ATTENTION: This operation must always be done when the fryer is off and the oil is cold.
Open the machine door.
Verify that the oil or water cleaning collector bin is positioned under the tank inside the cabinet.
Turn the butterfly claps so that the oil flows in the tank.
Once the tank has drained completely, close the butterly clap moving it in the original position.
Then make sure that the tap closes properly and that there are no leaks during operation.
to power the machine up: the power indicator (LED 1) lights up.
required temperature: the operating indicator (LED 2) lights up and then
then turn the selector
Rev. 0.00 / 2017 - pag. 14 di 47
EN
anti-