Impecca IWA15-QS30 Manual De Usuario página 14

STEP 4: FOAM STRIP ON WINDOW FRAME
• Affix the Foam seal (with adhesive) z to the bottom of the window sash and the
Window Base foam seal { to the window base. .
STEP 5: MOUNT THE UNIT HOUSING IN THE WINDOW FRAME
1. Place the unit housing on the window-
sill. The lower guide should be com-
pletely flush with the windowsill. Gen-
tly lower the window until it holds the
upper guide in place. Fasten the lower
guide to the window frame with two
Type C screws as shown.
2. Prepare the left and right bracket by
placing supporters on the upper side of the brackets. Use a Type F screw and nut
to fasten the supporter to the bracket as shown.
3. On the exterior side of the window, place the left and right brackets against the
window sill beneath the lower rails of the unit housing. Adjust the screws on the
brackets as necessary to allow a slight downward angle necessary (about 3°) for
draining condensation that forms during air conditioner operation. Fasten the unit
housing to the brackets with two Type E screws and bolts on the left and right side.
Sealing strip (with adhesive)
–14–