Dell PowerEdge R330 Manual Del Propietário página 82

Figure 36. Removing the 1.8-inch SSD tray
1 SSD tray
3 data and power cable
4 Slide the SSD carrier out of the system until it is free of the optical-drive slot.
5 Press the SSD release tab and lift the SSD from the tray.
Figure 37. Removing the 1.8-inch solid state drives from the SSD tray
1 SSD tray
3 SSD
Next steps
1 Depending on your system configuration, install an optical drive or two 1.8-inch solid state drives.
2 If you are not immediately installing an optical drive or 1.8-inch SSDs, install an optical drive blank.
NOTE: Blanks must be installed on empty optical drive or tape drive slots to maintain FCC certification of the system. The
brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
3 Follow the procedure listed in
82 Instalación y extracción de los componentes del sistema
Después de manipular el interior del
2 SSD
4 tray release tab
2 tabs on the tray
4 SSD release tab
sistema.