Installing The Cooking Components; Securing The Gas Cylinder Support Bracket; Securing The Chimney - Pit Boss CHARLESTON PB1230CC Instrucciones Y Recetas

18. INSTALLING THE COOKING COMPONENTS

Parts Required:
2 x Upper Cooking Rack (#1)
4 x Cooking Grids (#2)
Installation:
• Place the Cooking Grids, side-by-side, on the grid ledges inside of
both Main Barrels. Place the Upper Cooking Racks on the upper ledges
inside of both Main Barrels. The cooking rack will lock into place.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance is required.

19. SECURING THE GAS CYLINDER SUPPORT BRACKET

Parts Required:
1 x LP Gas Cylinder Support Bracket (#37)
4 x Screw (#D)
4 x Washer (#I)
4 x Locking Washer (#J)
Installation:
• Secure the LP Gas Cylinder Support Bracket to the right side of the cart
by using four screws, locking washers and washers.

20. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Cap (#3)
1 x Chimney Stack (#4)
1 x Chimney Gasket (#5)
2 x Screw (#A)
2 x Washer (#B)
2 x Locking Washer (#C)
Installation:
• Locate the chimney opening on the side panel of the Main Barrel. From
the outside, secure the Chimney Stack and Chimney Gasket to the side
panel using two screws, locking washers, and washers. The screws will
fasten to the pre-mounted nuts on the inside of the barrel.
• Next, secure the Chimney Cap by rotating the Chimney Cap screw into
the Chimney Stack.
NOTE: Adjust the chimney cap to affect the airflow inside the main
grill. If cooking at low temperature, keep the cap more open. Ensure
the Chimney Cap allows for air to escape.
16
18
1
2 2
19
37
20
5
1
3
4