Scanner Copy; Edit A Scene - Steren DMX-100 Manual De Instrucciones

8. Select SCENES button to store. All LEDs will blink three times. The LCD screen
will display stored Bank and Scene numbers.
9. Repeat steps 2 to 8 to store more scenes.
Cancel the Blackout function if the LED is turned on.
• A SCANNER button represents lighting equipment.
• You can access the 9 channels to 16 by pressing the Page Select button. This is required on
devices using more than 8 control channels.
• After changing page, you need to slide the Faders to activate them.
• There are 8 scenes available on each bank.

3.4.1 Scanner copy

You can copy a scanner' settings to another. Simply press and hold a button of
previously scheduled scanner and click another scanner to copy and store it. Press
BLACKOUT to deactivate.

3.4.2 Edit a scene

1. Press the PROGRAM button for 3 seconds.
2. Locate the scene at the BANK program. Use the BANK UP/DOWN arrows to
navigate between Bank programs.
3. Select the scene on Bank programs that you want to edit.
4. Adjust the FADERS for changing the appearance of the scene.
5 Click on the Midi/Add button and then the previously selected to edit scene button
again.
Press the Blackout button if the LED is lit.
Remember the number of edited scene on the controller, otherwise you might overwrite the
content of another scene, losing saved programming.
10
6. Press the Midi/Add button to prepare the storage.
7. Select a BANK (Bank, from 1 to 30), using the Bank Up-Down
arrows to change it, if necessary.