Delete A Sequence (Chase); Delete All The Sequences (Chase); Scenes Playback; Manual Scenes Playback - Steren DMX-100 Manual De Instrucciones

3.5.5 Delete a sequence (Chase)

1. Press and hold the PROGRAM button for 3 seconds.
2. Press the CHASE (1 to 6) which you want to delete.
3. Hold down the AUTO button and the button that corresponds to the sequence
(CHASE) and then release to delete the sequence. All LEDs will blink 3 times.
Programmed scenes remain in the controller. It affects only the sequence.
Warning: This procedure can cause the loss of all sequences (Chase) programming. However, all
the memories of scene will remain unchanged.

3.5.6 Delete all the sequences (Chase)

1. Press and hold the buttons DOWN BANK and AUTO of the
while the controller is turned off.

3.6 Scenes playback

3.6.1 Manual scenes playback

Every time you turn on the controller, it will be in the manual scene playback mode.
1. Ensure that none of the Music Trigger and Auto Trigger LEDs is lit.
2. Select the program that stores the scene that you want to run manually using
BANK UP /DOWN buttons.
3. Click the scene button to play it.
If you are in programming mode, press the PROGRAM button until the program LED turns off.
15