Publicidad
Idiomas disponibles
Idiomas disponibles
1a. Remove Lower fascia (Figure 2): Using a T25 torx bit, remove (5)
1b. Using an 8mm socket remove (4) bolts from bottom edge of fascia, (2) per side. Do
screws holding wheel well liner to fascia, both sides.
not remove the (4) torx screws from bottom edge of fascia.
1d. Disconnect the back up sensor wiring harness (4) places,
1c. Using a plastic trim tool, remove the lower fascia from upper part of fascia
starting at the outer edges near wheel wells while gently pulling rearward,
release the clips holding the fascia.
©2018 Horizon Global™ Corp - Printed in Mexico
Sheet 4 of 21
76245NP
09-05-18
Rev. A
Publicidad
