Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove caulk – using a utility knife, remove excess caulk from end panel
near hitch bracket mounting surface so the bracket sits flat against the end
panel, both sides. See Figure 3.
Figure 3
5.
Install Hitch and Bumper beam - Raise hitch and bumper beam into position aligning holes with studs in end panel. See Figure 1. Loosely reinstall the (6) existing
M10 flange nuts onto the studs in end panel.
©2018 Horizon Global™ Corp - Printed in Mexico
Remove
excess caulk
4. Apply sealant - apply silicone sealant to both hitch bracket mounting
surfaces. See Figure 4.
Figure 4
Sheet 6 of 21
76245NP
09-05-18
Rev. A
Publicidad
