Cutting Height Adjustments - Powersmart DB6701 Manual Del Usuario

ASSEMBLY INSTRUCTIONS
ATTACHING THE HANDLE TO THE MOWER BASE
3. Align the holes at the bottom of the arms of the lower
handle (D) with the posts extending from the side plates
on the reel mower body (E). Slide lower ends of handle
arms onto posts.

CUTTING HEIGHT ADJUSTMENTS

1. The cutting height of the mower can be adjusted from
5/6 – 1-4/5 in. with 4 positions for
adjustment height, using the roller assembly.
2. For the highest cutting level, move the adjustment
knobs to position A as shown in Fig. 4.
3. For the lowest cutting level, move the adjustment
knobs to position B as shown in Fig. 4.
4. Other cutting heights are achieved by moving the
adjustment knobs to any stop between the highest
and lowest positions.
NOTE:
The maximum grass cutting height for most grass types
is 3 in. If the grass exceeds 3 in., the following guidelines are
recommended; however, results will vary depending on lawn
type and condition.
Increase cutting height for initial cutting, then lower as needed
during repeat cutting.
Overlap cutting paths.
Mow the same path in opposite directions.
3
D
4
7
E
The highest
cutting position
position A
position B
The lowest
cutting position
The height
adjustment knob