Maintenance - Medline MDS3003 Guía De Operación

1. Do not drop this monitor or subject it to strong impact.
2. Avoid high temperature and sunlight. Do not immerse the monitor in water as this will
result in damage to the monitor.
3. If this monitor is stored near freezing, allow it to acclimate to room temperature before use.
4. Do not attempt to disassemble this monitor.
5. If you do not use the monitor for a long time, please remove the batteries.
6. It is recommended the performance should be checked every 2 years or after repair. Please
contact the service center.
7. If the monitor becomes dirty, please clean it with a soft dry cloth. Do not use any abrasive or
volatile cleaners.
8. No component in the monitor can be maintained by the user. The circuit diagrams,
component part lists, descriptions, calibration instructions, or other information which will
assist the user's appropriately qualified technical personnel to repair those parts of
equipment that are designated as reparable can be supplied.
9. The monitor can maintain the safety and performance characteristics for a minimum
of 10,000 measurements or three years.
10. It is recommended that the cuff is disinfected 2 times per week. Wipe the inner side of the
cuff that makes direct contact with the skin with a soft cloth and Ethyl alcohol (75-90%). Let
the cuff air dry before next use.
11. The cuff can maintain safety and performance characteristics for an average of 1,000
measurements.

MAINTENANCE

-24-