Installation And Cabling Diagram; Connection Diagram For The Alarm System Wiring Harness - BMW DWA V Instrucciones De Montaje

2. Installation and cabling diagram

F 36 0001 2W
Legend
1. Installation site for emergency-current siren
1a. Installation site for emergency-current siren
(alternative)
2. Bonnet contact switch near the right light unit
3. Ultrasonic sensor at the top of the right-hand
A pillar*
4. Ultrasonic sensor at the top of the left-hand
A pillar*
5. LED in the oddments tray in the centre
console (not on cars from Series E 36/5)**
6. Alarm system wiring harness
7. DWA control unit near the glove box
8. Cable installation route for cars from
Series E 36/5/C only (boot switch)***
8a. Cable installation route for cars from
Series E 36/2/3/4 only (boot switch)

3. Connection diagram for the alarm system wiring harness

F 36 82 914 R
Item Description
A White 24-pin plug
A1 Door contact switch branch,
front left
A5 Terminal 75 branch
(radio setting or ignition
key position I)
A6 Terminal 31 branch
A15 Terminal 30 branch
A16 Hazard lights system branch
A17 Central locking branch (close)
Cable colour/
Signal
cross-section
–––––
–––––
brown/grey
Negative with
0.75 mm
front left door
open
violet/white
Positive in
0.75 mm
ignition key
positions I and II
brown
Negative
0.75 mm
red/white
Positive
1.0 mm
blue/red
Negative with
0.75 mm
hazard lights
system button
pressed
yellow/blue
Positive for 0.5
0.75 mm
sec. when
closing and
opening the
central locking
* On cars from Series E 36/C, the ultrasonic
sensors are installed at the bottom of the
A pillar.
** On cars from Series E 36/5, the LED is
installed near the low beam switch.
*** On cars from Series E 36/5 with a base
module, branch A22 is connected direct
to the base module.
Insulate and tie back cables which are not
required.
Connection location in the car
On DWA control unit
Cars with central locking module only
White 26-pin plug X13012, pin 4
2
(cable colour brown/grey/yellow)
Cars after 9/93 with base module only
Green 26-pin plug X13254, pin 2
(cable colour brown/grey/yellow)
Cars with central locking module only
2 White 26-pin plug X13012, pin 7
(cable colour violet/white)
Cars after 9/93 with base module only
Joint connector X1235 (cable colour violet/white)
behind the glove box or black 6-pin plug X322, pin 2
(cable colour violet/white) in the left-hand footwell
Earth post X1166 in the right-hand front footwell
2
under the carpet
Cars with central locking module only
2
Black 5-pin plug X13013, pin 2
(cable colour red/green/yellow)
Cars after 9/93 with base module only
Black 15-pin plug X13252, pin 10
(cable colour brown/blue)
Hazard lights system switch, black, 5-pin plug X516,
2
pin 2 (cable colour brown/blue)
Cars with central locking module only
2
White 26-pin plug X13012, pin 24
(cable colour white/red/yellow)
Cars after 9/93 with base module only
Yellow or violet 26-pin plug X13253, pin 17
(cable colour white/red/yellow)
23