Installation; Preparing The Base Frame; Installing The Integrated Fat Drain - Rational iCombi Pro Manual De Instalación

4 | Installation

8 Drain pipe
9 Ball valve with handle
10 Connection pipe
11 Double socket
12 Silicone seal double socket
13 Pipe bracket back panel
14 Silicone seal HT pipe
15 Bracket for ball valve
16 Copper seal
17 Drip pan
18 Pipe drip pan
19 Sealing plugs for cooking chamber,
with attachment and chain
20 Connection with hopper opening
21 Drain connection
4 Installation

4.1 Preparing the base frame

Base frame with back panel:
Make a hole in the back panel of the base
frame [ Photo 02].
Base frame without back panel
[ Photo 03]:
1. Hang the retaining plate on the back of
the base frame on the edge of the
table.
2. Tighten the 2 screws on the retaining
plate.

4.2 Installing the integrated fat drain

Installing the ball valve and drain pipe
1. Seal the threads of the two pipe pieces
for the ball valve with Teflon tape
[ Photo 04].
2. Install both parts of the bracket on the
ball valve with the pipe bracket and the
connection pipe [
80.51.386_iCombi Pro-iCombi Classic_IFA TG_IM_V01_EU-west
Photo 05].
3. Turn the pipe bracket so that it is at a
90° angle to the bracket.
4. Install the pipe seal on the pipe socket
in the rear panel of the unit
[ Photo 06].
5. Plug the pipes into the rear panel of
the unit [ Photo
6. Insert the piping into the base frame
[ Photo 08].
7. Slide the ball valve into the top rail of
the base frame [
8. Slide the piping into the pipe socket of
the ball valve [
9. Tighten the clamping screws on the
ball valve bracket [
10. Place the front fat collector canister in
front of the base frame and the rear fat
collector canister in the base frame
[ Photo 12]. The rear canister must
be positioned in the base frame in such
a way that the front fat collector canis-
ter can be placed in front of it after fur-
ther preparation.
11. Insert the drain pipe into the front fat
collector canister and into the pipe
bracket [ Photo
12. Turn the drain pipe so that the pin
locks in the pipe bracket
[ Photo 14].
13. Slide the fat collector tray into the bot-
tom slot of the unit [
14. Insert the piping in the cooking cham-
ber into the fat collector tray
[ Photo 16]. Attach the sealing plug
to the hopper in the cooking chamber.
Opening/closing the hopper
1. Leave the hopper open in the cooking
chamber when using the integrated fat
drain.
en
07].
Photo 09].
Photo 10].
Photo 11].
13].
Photo 15].
9 / 56