Coffee Flow; Using The "Crema" Filter Holder; Using The Brass Filter Holder - Saeco Via Veneto Instrucciones De Uso

24
(6), turning it in an anti-clockwise
direction and press the coffee switch (4).
• Wait until a steady stream of water flows
from the tube ("Pannarello").
• Press the coffee switch (4) again and close
the "hot water/steam" knob (6), turning
it in a clockwise direction.
The machine is now ready to make a perfect
cup of coffee.
5

COFFEE FLOW

Warning! Do not remove the
filter holder by turning it
manually in a clockwise direction while
the machine is producing coffee.
Danger of burning.
• During this operation, the "machine on"
light (12) will go on and off. This is
perfectly normal and shall not be
considered as a failure.
• Before using the machine, make sure that
the "hot water/steam" knob (6) is closed
and that there is sufficient water in the
tank.
• If the machine is off, turn it on by the
main switch (3): the light (11) will go on.
• Wait for the "machine on" light (12) to
be on. Now the coffee maker is ready.
5.1

Using the "Crema" filter holder

• Place the filter (14) inside the "Crema"
filter holder (13).
30
• Insert the "Crema" filter holder (13)
in the dispenser unit (7) from below,
turning it from left to right until it locks
into place.
• Let go of the filter holder handle.
Automatically the handle will move slightly
to the left.
This movement guarantees the perfect
functioning of the filter holder.
31
• Place a cup under the filter holder.
To warm up the filter holder and the cup,
press the coffee switch (4); water will
begin to drip from the filter holder (this
operation is only necessary for the first
cup of coffee).
• When the cup is sufficiently full, press the
coffee switch (4) again.
32
• Remove the filter holder from the
machine by turning it to the left and pour
out any water that is left inside.
• With the special "Crema" filter holder (13)
supplied with the machine, it is not
necessary to change the filter to obtain
one or two cups of coffee.
29
• To make one or two cups of coffee,
add 1 or 2 even measures of ground
coffee to the filter.
• Clean the edges of the filter holder from
any excess of coffee grounds.
30
• Insert the "Crema" filter holder (13)
in the dispenser unit (7) from below,
turning it from left to right until it locks
into place as directed above.
31
• Position two warmed cups under the
filter holder, making sure that they are
directly under the coffee spouts.
• Press the coffee switch. Wait until the cups
are sufficiently filled.
• Press the coffee switch again to stop the
coffee flow.
32
• When the coffee flow has ceased,
remove the filter holder and empty out
the excess coffee grounds.
Cleaning note: always keep the
i
"Crema" filter holder clean by
removing it and washing it with
drinking water.
5.2

Using the brass filter holder

• Place the filter (17 or 16, single or twin
cup, depending on the number of coffees
Coffee flow