Installing Batteries And Setting The Clock; Wrapping The Cuff Around Your Wrist - Nissei WS-820 Instrucciones

INSTALLING BATTERIES AND SETTING THE CLOCK

1. Remove the battery cover in the arrow direction.
2. Install two AAA alkaline dry cells in the battery compartment, giving
attention to their polarity.
The cells can be easily installed by pushing them while pressing their (-)
side against the spring.
CAUTION! Do not use rechargeable batteries.
3. Replace the battery cover.
4. Year flashes on the display.
Clock can be set only after the batteries are reinstalled. Setting the
clock correctly ensures storage of the measurement with the correct
date and time.
Use memory M1 button to increase the flashing year and memory M2
button to decrease the year. Press START button to confirm and move
to next step.
5. Month flashes. Adjust with M1 and M2 buttons and press START
button to confirm.
6. Day flashes. Adjust with M1 and M2 buttons and press START button

WRAPPING THE CUFF AROUND YOUR WRIST

1. With the palm of your left hand up, put the cuff on your wrist so that
the display screen is on the same side as your palm.
2. Adjust the cuff, with your palm up, until its top edge is positioned 5 to
to confirm.
7. Hour flashes. Adjust with M1 and M2 buttons and press START button
to confirm. The clock operates in 24-hour mode.
8. Minute flashes. Adjust with M1 and M2 buttons and press START
button to confirm.
The clock is set and the unit is turned off.
Battery replacement indication
Replace all the batteries when the battery replacement indication appears
on the display or nothing is displayed when START button is depressed.
About 300 measurements can be made after installation of new AAA alkaline
dry cells. The enclosed batteries are for monitoring, and their life may be
shorter than that of commercial batteries.
The used electrical and electronic products are not household
waste. Follow your national/local recycling rules to dispose of
them properly. In the EU countries, please refer to waste
management symbol(s) marked on the package or the instrument.
10 mm from the bottom of your palm. Place the unit at the center of
your wrist.
3. Fasten the cuff around your wrist so that there is no space between
-12-
Fig.2 page 3
Fig.3 page 4