Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 47
Heart mark flashes when pulse rhythm detected during measurement
was irregular.
2. Press either one of memory buttons, M1 or M2, and the result is stored
in the selected bank.
The selected memory bank number is shown on the display. The result
is stored in the bank selected when the unit is turned off. Irregular pulse
rhythm indication will not be stored, only blood pressure and pulse rate
are stored. When a measurement resulted in an error, it will not be
stored.
3. Press START button to turn off the power.
If you forget to turn off the unit, it will automatically turn off after 3 minutes.
Do not execute repeated measurements. This will cause
engorgement of the wrist and correct values will not be obtained. Let
your wrist rest for at least 5 minutes.
Irregular pulse rhythm indication
Heart mark flashing in measurement result display indicates irregular pulse

MEMORY FUNCTION

Measured result is stored in either M1 or M2. Each of two memory banks can
hold up to 30 results and their average. When the number of measurements
exceeds 30, the oldest data will be deleted to record new data. You may
rhythm. Irregular pulse rhythm can be a
result
of
body
movement
measurement or can be because of
arrhythmias.
Although
appearance of the indication under quiet
measurements may suggest arrhythmias,
do not make any judgment on your own
before consulting with your doctor.
Automatic Repressurization
If the pressure applied is judged insufficient in the early phase of
measurement or if movement of the hand or wrist occurs during
measurement, the unit will inflate again to a level about 40 mmHg higher.
Automatic Repressurization is repeated until a measurement is made.
However, this does not indicate a problem.
To manually control pressurization, hold down START button immediately
after the start of inflation and release it when the pressure reaches the
level 50 mmHg higher than the expected maximum systolic pressure. If the
pressure value has exceeded 190 mmHg, the inflation will stop when the
key is released. Pressure can be increased to approximately 300 mmHg.
decide which bank to store your measurement results to avoid data mixture
with someone else's, or may use two banks to save data measured in the
morning and evening separately.
-14-
MEASURING METHOD
regular pulse rhythm
during
constant
An example of irregular pulse
rhythm compared to regular
pulse rhythm
Fig.6 page 8

Publicidad

Tabla de contenido
loading

Productos relacionados para Nissei WS-820

Tabla de contenido