Troubleshooting Tips; Environmental Instructions - Würth Jumpstarter 12 V/24V/2 x 16 Ah Manual De Instrucciones

Fault
Reverse connection LED [11] not illuminated:
Reverse connection LED [11] shows red.
LEDs [2] and [10] light red.
LED [4] or [7] lights red.
Device switches off after start-up attempt.
Maintenance and cleaning
Attention!
Clean the device only when the mains
plug has been removed.

Environmental instructions

Do not throw the device away with
normal domestic waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all packaging in
an environmentally compatible manner.
Batteries:
Do not dispose of batteries with domestic waste,
do not expose to fire or water. Collect and recy-
cle batteries or dispose of with due care for the
environment.
12

Troubleshooting Tips

Cause
– Booster cable clamps are not connected.
– Vehicle battery voltage is less than 4 V or vehicle
battery is missing altogether.
– Short circuit in a vehicle battery cell
– Booster cable clamps are connected incorrectly.
– Charge of booster kit too low; charging not
possible.
– No voltage on booster cable clamps; start-up
procedure not possible.
– Charge level of booster kit battery too low.
– Fuse integrated into the device defective.
– Vehicle causes a short circuit; remove defective
vehicle battery
The following guarantees apply for this Würth
device:
– Battery booster kit and charger: 24 months
– Battery in battery booster kit: 12 months
– Cable clamps and fuses are excluded as they are
wear parts.
The warranty period starts with the date of purchase
(verified by invoice or delivery document).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims under warranty can only be accepted if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or an
authorised Würth customer service workshop. Sub-
ject to technical changes without prior notice.
We accept no liability for printing errors.
If. in spite of careful manufacturing and testing
processes, the device becomes faulty, a repair by
Würth masterService should be arranged. With any
enquiries or spare parts orders, always quote the
article number as given on the device type plate.
Warranty
Accessories and spare parts