WIRING INSTRUCTIONS
WARNING
To avoid possible electrical shock, be
sure electricity is turned off at the main fuse
box before hanging.
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for
advice, as it must be grounded for safe
operation.
1. Connect the green grounding lead from the
downrod/hanger ball assembly (C) and the green
grounding lead from the hanger bracket (B) to the
supply grounding conductor (this may be a bare
wire or wire with green colored insulation).
Securely connect wires with wire connectors
(CC). Securely connect the white fan motor wire
to the white supply (neutral) wire using wire
connector (CC). Securely connect the black
fan motor wire and blue wire to the black supply
wire using wire connector (CC). (Fig. 1)
Hardware Used
Wire
CC
Connectors
2. After connections have been made, turn leads
upward and carefully push leads into the outlet
box, with the white and green leads to one side
of the box and the black and blue leads toward
the other side. The wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and the ungrounded conductor
on the other side of the outlet box. (Fig. 2)
WARNING
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors
except for the ground wire. Do not
operate fan until the blades are in place.
Noise and motor damage could result.
1
CC
x 3
2
Green Wire
from Hanger
Bracket (Ground)
10
Green Wire
White Wire
from Supply
from Supply
(Ground)
White Wire
from Fan
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Hanger
Ball (Ground)
C
Green Wire
White Wire
from Supply
from Supply
(Ground)
White Wire
from Fan
Green Wire
from Hanger
Ball (Ground)
CC
Listed
Outlet Box
Household
Supply
Black Wire
from Supply
Blue Wire
from Fan
Black Wire
from Fan
B
Listed
Outlet Box
Household
Supply
Black Wire
from Supply
Blue Wire
from Fan
Black Wire
from Fan