Explosive hazard—DO NOT use the oximeter in environment with
inflammable gas such as some ignitable anesthetic agents.
DO NOT use the device while the testee measured by MRI and CT.
The disposal of scrap instrument and its accessories and packing
(including battery, plastic bags, foams and paper boxes) should
follow the local laws and regulations. Do not place them where
children can reach them.
Please check the packing before use to make sure the device and
accessories are totally in accordance with the packing list, or else
the device may have the possibility of working abnormally.
Please choose the accessories and probe which are approved or
manufactured by the manufacturer, or else it may damage the
device.
The device can only be matched with the compatible probe.
Please don't measure this device with functional tester for the
device's related information.
Parts of this device are not allowed to be serviced or maintained
while in use with the patient.
1.3 Attention
Keep the device away from dust, vibration, corrosive substances,
explosive materials, high temperature and moisture.
If the oximeter gets wet, please stop operating it.
When it is carried from cold environment to warm or humid
environment, please do not use it immediately.
DO NOT operate keys on front panel with sharp materials.
High temperature or high pressure steam disinfection of the
device is not permitted. Refer to User Manual in the relative
chapter (7.1) for instructions of cleaning and disinfection.
Do not have the device immerged in liquid. When it needs
cleaning, please wipe its surface with medical alcohol by soft
material. Do not spray any liquid on the device directly.
When cleaning the device with water, the temperature should be
lower than 60°C.
The fingers which are too thin or too cold may affect the normal
measure of the patients' SpO2 and pulse rate, please clip the thick
finger such as thumb and middle finger deeply enough into the
probe.
The device can be used to adult or infant. Whether the device is
used to adult or infant, it depends on the probe selected.
The update period of data is less than 5 seconds, which is
changeable according to different individual pulse rate.
EN