PULOX PO-900 Instrucciones Para El Usuario página 40

software, and return to the system setting menu interface after 2
seconds.
E. Equipment ID: see the ID information of device.The ID of the
device can be set by the PC software.Please refer to <SpO
Assistant user manual> for detail.
F. Factory Default: move the choice bar to the "Factory Default"
item, then press the menu button to pop-up "Factory Default"
window. Press the up/down button to choose whether to resume
Factory Default, and press menu button to affirm setting, then
press the return button to return the system setting menu
interface.
Display setting
In the main menu interface, choose "Display" item, then press the
menu button to enter the display setting menu as Figure 7:
A. Brightness: move the choice bar to the "Brightness" item,then
press the left/right button to set (three levels)
B. Mode: move the choice bar to the "Mode" item,then press the
left/right button to switch display mode (two kinds of display
mode) as figure 8 and figure 9.
Note: in measure interface, the user could press mode switch button
to switch display mode too.
Figure 7 Display setting menu
EN
2