VITO AGRO VIMBD2A Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
UsE
1 - Put water: before first use, put
water in the pump, so that it can
suck automatically after reboot.
2 - Start the engine:
A) Electric start:
- Open the fuel tap
- Turn the key to the right (counter
clockwise)
B) Manual start:
- Open the fuel tap
- Turn the key (up to the first point)
- Move the lever to position "start".
- Pull the choke lever gently.
- Pull the lever until resistance is
felt. Drop gently.
- Push the decompression lever
and release it.
- Pull the rope hard and fast.
If the engine does not start, start
again from step 3.
mAINtENANCE
According to the general regula-
tions, since the height increases,
the pressure decreases accordingly,
and the suction capacity will also
decrease. Decreased numerical val-
ues can be achieved by using 10m
to reduce the values of atmospheric
pressure.
The suction line will be improved
with short connections and lines
avoiding unnecessary losses.
The suction line should be fixed to
avoid vibration. Check the pump
and connection losses before use,
such leakage.
There should be a gap between the
filter the stream and its margins.
The filter should be soaked more
than 0.3mt to prevent entry of
air and away more than 1.2mt the
bank of the river to prevent entry
of debris.
stRUCtURE
Diesel engine and centrifugal pump,
light and easy to move.
Constitution: pump, driver flow,
filter and seals.
KEY POINts
- Make sure that the connection
made between the entry point of the
hose and the water pump was found
packed properly.
- Input terminal should be protected
with the filter, preventing entry of air
or particles, preventing damage tzo
the pump.
- Put water in the pump (bleeding)
before first use.
- Forbidden to use without being to
suck water.
- Remove all water from the pump
before disconnecting.
INstAllAtION
OF sUCtION HOsE
A flexible rubber hose should be
placed at the ends.
Warning: once placed hoses,
use the clamps provided to hold
properly.
Keep this manual in a handy place
so as to refer to it when needed. It
is considered a constituent part of
the pump and should remain with
the pump if it is sold again.
The pump is designed to pump
water unfit for human consumption.
Other use than specified may cause
injury to the operator or damage to
the pump.
Always perform an inspection
before starting the pump. This way
you can avoid an accident or equip-
ment damage.
REsPONsIBIlItY
OF tHE UsER
It is the user's responsibility to
provide the necessary safeguards to
protect people and property. Learn
how to stop the pump quickly in an
emergency. If for any reason leave
the pump, switch off the engine. Fa-
miliarize yourself with the controls
and connections.
Make sure that any user gets the
proper instruction. Do not allow
children to operate the equipment.
Keep children and animals away
from work area.
OPERAtION
Just pump water that is not intended
for human consumption.
Pumping flammable liquids such as
gasoline or heating oil can cause a
fire or explosion causing serious in-
jury. Pumping salt water, beverages,
acids, chemical or liquid which
promotes corrosion can cause dam-
age to the pump.
REFUEl CAREFUllY
Diesel fuel is extremely flammable
and its vapors can explode. Refuel
outdoors, in a well ventilated area
with the engine stopped and the
pump on a level surface. Do not fill
the fuel tank above the filter. Never
smoke near the diesel and keep po-
tential sources of sparks or flames
away. Always store diesel in con-
tainers approved for that purpose.
Make sure that any spilled fuel has
been cleaned before starting the
engine. After refueling, make sure
the tank cap is closed properly.
EsCAPE HOt
During operation, the exhaust gets
very hot and stays hot for several
minutes after turning off the engine.
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Agro vimbd3aAgro vimbd4a

Tabla de contenido