Instructions Before Installation - Domestic GROUP WAECO MagicTouch MT400 Instrucciones De Montaje Y De Uso

Instructions before installation

5 Instructions before installation
Supplementary to fig. 3
NOTE
I
If you do not have sufficient technical knowledge for installing and
connecting components in vehicles, you should have a specialist
install the radio remote control in your vehicle.
Your vehicle should meet the following requirements to be able to open and
close it with MagicTouch:
12 V operating voltage
Central locking system
5.1 Setting the configuration
Clarify the following before installing and programming the system:
Is the driver's door equipped with its own servo motor for locking?
If no: retrofit a servo motor (e. g. WAECO ML-11).
Some manufacturers equip their vehicles with a power-saving central
locking system. In these vehicles, there is no servo motor in the driver's
door; there is an electrical switch instead.
Do the door contacts have a negative or positive charge?
The system must be programmed accordingly, see chapter "Program-
ming MagicTouch" on page 34.
Is it permitted by law in your country for the warning system to flash
when opening and closing the central locking system?
The system must be programmed accordingly, see chapter "Program-
ming MagicTouch" on page 34.
What should the convenience function control, e. g.:
– the dipped headlights for 10 sec. (coming home function)
In this case, clarify whether the dipped headlights are positively or
negatively charged.
– electric power windows and sliding roof.
The system must be connected and set up accordingly, see chapter "Set-
ting up the convenience function" on page 29.
Is the maximum power of 10 A sufficient?
If no, an additional relay must be used.
24
MagicTouch MT400