Domestic GROUP WAECO MagicTouch MT400 Instrucciones De Montaje Y De Uso página 27

MagicTouch MT400
What type of switching function does the original central locking
system have?
The system must be programmed accordingly, see chapter "Connecting
MT400 to the central locking system" on page 28.
You will require the circuit diagram for the central locking system to do
so. You can obtain this from your vehicle dealership. There is corre-
sponding information for some vehicle in chapter "Vehicle-specific data"
on page 29.
If no original circuit diagrams are available and you cannot find your vehi-
cle in the table in chapter "Vehicle-specific data" on page 29, you will
need to determine the function of the control cables that run from the
control unit for the central locking system to the vehicle doors.
NOTICE!
A
Only connect MagicTouch using the control cables for the central
locking and not using other cables.
Connection to other cables than the control cables or using an in-
correct circuit plan can lead to defects in the central locking system
and the remote control.
How long does the central locking system have to be activated for?
The activation time for MagicTouch was set to 0.7 sec. at the factory.
In some vehicles, for example Mercedes, an activation time of 0.7 sec.
might not be sufficient to completely activate the central locking system.
To program the system to 3 sec., see chapter "Programming Magic-
Touch" on page 34.
Instructions before installation
25