Operating Magictouch; Using The Remote Control - Domestic GROUP WAECO MagicTouch MT400 Instrucciones De Montaje Y De Uso

MagicTouch MT400
✓ When the status LED and hazard lights are lit continually, the function has
been programmed.
You can now program other functions or exit programming mode.
To exit programming mode:
➤ Switch on the ignition.
9

Operating MagicTouch

9.1

Using the remote control

See fig. f
Observe the following instructions when you use MagicTouch:
CAUTION! Danger of crushing!
!
Never allow the electric windows to be closed while they are unat-
tended.
To ensure the remote control functions properly, a disturbance-free con-
nection between the hand-held transmitter and the control unit is required.
Depending on where the control unit is installed, and the transmission
power of nearby sources of interference, the range is up to 20 m.
Each time the hand-held transmitter is used, it sends a new code (rolling
code). For this reason, the control unit might not recognise the hand-held
transmitter immediately if you use the hand-held transmitter too frequently
without the control unit receiving the transmission signal. In this event,
press the hand-held transmitter again another one to three times; after the
third attempt at the latest, the control unit will detect the hand-held trans-
mitter again.
To close the central locking:
➤ Press the "Close" button on the hand-held transmitter.
✓ If the ignition is switched off, the hazard light flashes once for confirma-
tion.
✓ When set: the convenience function is activated.
✓ The interior light is switched off.
✓ The status LED starts flashing.
Operating MagicTouch
35