Domestic GROUP WAECO MagicTouch MT400 Instrucciones De Montaje Y De Uso página 31

MagicTouch MT400
7.3 Setting up the convenience function
See fig. d
NOTICE! Risk of damage
A
The maximum output current of 10 A for the convenience function
may not be exceeded.
If you would like to activate larger consumers, you will need to use
an additional relay (operating current relay) with a recovery diode.
You can also set the convenience function to be a "coming home function",
for example: during locking, the dimmed headlight is switched on for 10 sec.
The function has to be programmed („Programming MagicTouch" on
page 34). You can also switch the dipped headlights on by pressing the
"Comfort" button for 10 sec (factory setting). While the convenience function
is running, this can be switched off at any time by pressing the "Comfort" but-
ton again.
➤ Connect the pink cable to the original vehicle cable which originates from
the light switch and which connects the positive signal for the dipped
headlights (terminal 56b, fig. d).
➤ Negatively-connected dipped headlights (fig. d A):
Connect the brown cable to the vehicle earth (Terminal 31).
➤ Positively-connected dipped headlights (fig. d B):
Connect the brown cable to +12 V (Terminal 30), which must be protected
with at least 10 A.
7.4 Vehicle-specific data
NOTICE! Risk of damage
A
Check the polarity before connecting.
The following table does not claim to be exhaustive. You can obtain informa-
tion on other vehicles on request from WAECO (see address on the back).
We reserve the right to make alterations.
CL = central locking
Connecting MT400
29