Operating The Everest 600 Printer; Power On Or Off The Everest 600 Printer; Power On Or Off A Standalone Printer; Power On Or Off A Printer Connected To An Autoloader Or Autoprinter - Rimage Everest 600 Guia Del Usuario

Operating the Everest 600 Printer

This section provides the information needed to operate your Everest 600
printer.

Power On or Off the Everest 600 Printer

The Everest 600 printer does not have a power switch. The printer is
powered on and off according to your system setup. Refer to the sections
below.

Power On or Off a Standalone Printer

Follow these steps for a standalone Everest 600 printer:
• To power on the printer, connect the power cord from the printer to a
power outlet.
• To power off the printer, disconnect the power cord from the rear of the
printer.
Power On or Off a Printer Connected to an Autoloader or
AutoPrinter
Follow these steps if your Everest 600 is connected to an autoloader or
AutoPrinter:
• To power on the printer, power on the autoloader or AutoPrinter.
• To power off the printer, power off the autoloader or AutoPrinter.
2001474_B
Tip: The printer enters power saving mode if it is idle for more than 30
minutes. When this occurs, the printer takes 2-3 minutes to warm up after a
job is sent to the printer.

Place a Disc on the Printer Tray

Use this procedure to place a disc on the printer tray.
1. Press the operator button. The printer tray opens.
2. Place the disc on the print pad. Make sure that the printable surface
Important! To avoid scratching or damaging the recording surface of the
disc, the disc must not rest on the holding pins or the centering pin.
For more information visit rimage.com/support
faces up, and the stacking ring faces the print pad.
Print Pad
Holding Pins
Centering Pin
Printer Tray
10